Dual Purpose Foam Cleaner is an aerosol product containing a solvent for cleaning all uncured PU foams.

It attaches to gun foam applicators for purging through; also includes a spray nozzle for use without applicator to remove wet foam from the outside of the gun and from most building substrates.

USES

▪ Cleaning PU foams from guns and nozzles.

▪ Cleaning spilt PU foam from surrounding areas

PRODUCT INFORMATION 

Packaging 500ml aerosol.

Shelf Life Use within 12 months Storage Conditions Store in cool dry conditions between + 5°C and 25°C.

APPLICATION INSTRUCTIONS 

SUBSTRATE PREPARATION

When cleaning spilt/excess foam, ensure surrounding areas are protected with impervious masking tape to prevent attack by the solvents in this product.

APPLICATION METHOD / TOOLS 

The following are recommended tips for cleaning foam in all common situations.

If foam in a gun is allowed to cure, the gun will become completely useless, as no solvent will dissolve PU Foam once cured.

The following guidelines are given to avoid unnecessary cost of replacement.

1.Gun foam may be left attached to a gun for a maximum of 7 days after use. If left for longer, there is a risk of the foam curing from the nozzle inwards or propellant leaking out.

If foam is left attached to the gun, spray EVERBUILD® Dual Purpose Foam Cleaner over the outside of the discharge nozzle before storage to remove any residues which may seize up the valve.

2. When you have finished using foam on a project, and do not intend to use the gun again within 7 days, remove the foam can (CARE – GLOVES/GOGGLES).

When you have read the usage/safety instructions on the can, attach EVERBUILD® Dual Purpose Foam Cleaner to your gun by screwing the canister onto the gun adapter until it will go no further, taking care not to cross thread or over tighten the canister.

Pull the trigger on the gun to release the solvent into the gun barrel and discharge the solvent into a suitable container for disposal. Only stop discharging the cleaner when the solution being ejected from the gun is completely clear. Leave the EVERBUILD® Dual Purpose Foam Cleaner attached to the gun for 5 minutes to allow the solvent in the gun to work on the residues inside. Pull the trigger once again until only clear solvent emerges.

Leave for a further 5 minutes and repeat this process 2 or 3 times until the gun is completely clear.